4/19/2021 0 Comments Uet609 Manual
Taking longer than 30 seconds, pressing any other key or entering an invalid code will cause the status light to blink quickly three times.
Uet609 For Free Report ThisSee Full Reader of 16 date post 18-Sep-2018 Category Documents view 235 download 0 SHARE Download for free Report this document Embed Size (px) 344 x 292 429 x 357 514 x 422 599 x 487 Transcript of Universal Projector Remote Controluniv.The Universal Projector Remote control uses two AA.Page 1 Cover VP3720 SMK-Link Electronics Universal ProjectorRemote Control Table of ContentsRegulatory Information.1 Getting Started.3 Setting your Projector.4 Entering Library Codes.4 Learning From Another Remote.5 Searching For A Code.6 Show Current Code.7 Factory Reset.8 Remote Control Layout.9 Appendix: Library Codes List.11 Page 1 Regulatory InformationRegulatory Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Certification This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-ence by one or more of the following measures: Reorient or relocate the receiving antenna. Page 2 Consult the dealer or an experienced radioTV technician for help. Notice: Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Extension cables are not recommended, if used, they must be shielded in order to comply with the emission limits. IC Certification The term IC before the certificationregistration number only signifies that the Industry Canada technical specifications were met. Declaration of conformity Hereby, SMK-Link Electronics Corporation declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 19995EC. All trademarks and registered trademarks mentioned in this document are the property of their respective owners. Features and specifications are subject to change without notice. SMK-Link Electronics, Inc. Page 3 Getting StartedThe Universal Projector Remote control uses two AA batteries. Remove the battery cover by pressing down on the battery door and sliding in the direction of the arrow. ![]() The orientation of the batteries is indicated in the battery compartment. TITLE: REVISIONDO NOT SCALE DRAWING MATERIAL: DATESIGNATURENAME DEBUR AND BREAK SHARP EDGES FINISH:UNLESS OTHERWISE SPECIFIED:DIMENSIONS ARE IN MILLIMETERSSURFACE FINISH:TOLERANCES: LINEAR: ANGULAR: Q.A MFG APPVD CHKD DRAWN Page 4 Setting your ProjectorEntering Library CodesTo test a four-digit code to see if it controls your projector, please complete the following steps. Some brands have multiple codes which work for different models. ![]() ![]() As you enter each digit of the code, the status light will briefly turn off.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |